Haken Audio Slim Continuum: MIDI CC, NRPN and OSC map¶
The Haken Audio Slim Continuum as named OSC addresses — 30 CC — ready to use from Claude (MCP), SuperCollider, Sonic Pi, TouchDesigner or any OSC app via osc-bridge.
| Device | Haken Audio Slim Continuum |
|---|---|
| Vendor | Haken Audio |
| OSC prefix | /slim_continuum |
| Source | 📦 Derived from MIDI Guide (community CC/NRPN data) |
| Firmware | unknown |
| Revision | per pencilresearch canonical CSV |
| Upstream | pencilresearch |
| Data licence | CC-BY-SA-4.0 — MIDI Guide (https://midi.guide) by Pencil Research and contributors |
| Driver file | devices/haken-audio/slim_continuum.pencilresearch.fw-unknown.json |
Not tested on the device yet
This driver comes from documentation or community data and has not been checked on real hardware. If you own one, a quick test and a pull request promoting it helps everyone — see CONTRIBUTING.
How do you control it?¶
Find the MIDI ports, then start the bridge with this driver:
osc-bridge detect # prints the ready-to-run line for what is plugged in
osc-bridge run --device devices/haken-audio/slim_continuum.pencilresearch.fw-unknown.json --out-port <N> --in-port <M>
Then send OSC to 127.0.0.1:7777, for example:
From Claude or any MCP client, the osc-bridge mcp server exposes this driver as slim_continuum: ask “what can the Haken Audio Slim Continuum do?” and it reads this map with list_routes. See the MCP guide.
MIDI CC and NRPN parameters (30)¶
| OSC address | CC | NRPN (MSB/LSB) | Range | Nature | Section |
|---|---|---|---|---|---|
/slim_continuum/pitch/octave_shift |
8 | 0–127 | continuous | Pitch | |
/slim_continuum/polyphony/mono_switch |
9 | 0–127 | continuous | Polyphony | |
/slim_continuum/pitch/fine_tune |
10 | 0–127 | continuous | Pitch | |
/slim_continuum/macros/macro_i |
12 | 0–127 | continuous | Macros | |
/slim_continuum/macros/macro_ii |
13 | 0–127 | continuous | Macros | |
/slim_continuum/macros/macro_iii |
14 | 0–127 | continuous | Macros | |
/slim_continuum/macros/macro_iv |
15 | 0–127 | continuous | Macros | |
/slim_continuum/macros/macro_v |
16 | 0–127 | continuous | Macros | |
/slim_continuum/macros/macro_vi |
17 | 0–127 | continuous | Macros | |
/slim_continuum/gain/post_level |
18 | 0–127 | continuous | Gain | |
/slim_continuum/gain/digital_in_level |
19 | 0–127 | continuous | Gain | |
/slim_continuum/recirculator/r1 |
20 | 0–127 | continuous | Recirculator | |
/slim_continuum/recirculator/r2 |
21 | 0–127 | continuous | Recirculator | |
/slim_continuum/recirculator/r3 |
22 | 0–127 | continuous | Recirculator | |
/slim_continuum/recirculator/r4 |
23 | 0–127 | continuous | Recirculator | |
/slim_continuum/recirculator/mix |
24 | 0–127 | continuous | Recirculator | |
/slim_continuum/gain/pre_level |
26 | 0–127 | continuous | Gain | |
/slim_continuum/gain/attenuation |
27 | 0–127 | continuous | Gain | |
/slim_continuum/rounding/round_initial |
28 | 0–127 | continuous | Rounding | |
/slim_continuum/pedal_functions/sustain |
64 | 0–127 | continuous | Pedal functions | |
/slim_continuum/surface/stretch |
65 | 0–127 | continuous | Surface | |
/slim_continuum/pedal_functions/sostenuto_1 |
66 | 0–127 | continuous | Pedal functions | |
/slim_continuum/pedal_functions/sostenuto_2 |
69 | 0–127 | continuous | Pedal functions | |
/slim_continuum/eq/tilt |
83 | 0–127 | continuous | EQ | |
/slim_continuum/eq/crossover |
84 | 0–127 | continuous | EQ | |
/slim_continuum/eq/mix |
85 | 0–127 | continuous | EQ | |
/slim_continuum/compressor_tanh/threshold_drive |
90 | 0–127 | continuous | Compressor / TANH | |
/slim_continuum/compressor_tanh/attack_na |
91 | 0–127 | continuous | Compressor / TANH | |
/slim_continuum/compressor_tanh/ratio_makeup |
92 | 0–127 | continuous | Compressor / TANH | |
/slim_continuum/compressor_tanh/mix |
93 | 0–127 | continuous | Compressor / TANH |
Performance MIDI¶
Notes, pitch bend and any CC are also available: /slim_continuum/note/on <note> <velocity>, /slim_continuum/cc/<number> <value>, /slim_continuum/pitchbend <0-16383>, /slim_continuum/program_change <n>.
Limitations¶
CC/NRPN only. SysEx (preset management, display control, bulk dump/load, vendor-proprietary opcodes) is NOT covered by pencilresearch. To extend this device with SysEx, sniff the vendor editor, add `sysex.header/footer` + `commands` blocks, and use `update_device.md` PR template.