Eventide SPACE: MIDI CC, NRPN and OSC map¶
The Eventide SPACE as named OSC addresses — 11 CC — ready to use from Claude (MCP), SuperCollider, Sonic Pi, TouchDesigner or any OSC app via osc-bridge.
| Device | Eventide SPACE |
|---|---|
| Vendor | Eventide |
| OSC prefix | /space |
| Source | 🎛️ Derived from an Electra One community preset |
| Revision | per Electra preset |
| Upstream | electra-preset |
| Driver file | devices/eventide/space.json |
Not tested on the device yet
This driver comes from documentation or community data and has not been checked on real hardware. If you own one, a quick test and a pull request promoting it helps everyone — see CONTRIBUTING.
How do you control it?¶
Find the MIDI ports, then start the bridge with this driver:
osc-bridge detect # prints the ready-to-run line for what is plugged in
osc-bridge run --device devices/eventide/space.json --out-port <N> --in-port <M>
Then send OSC to 127.0.0.1:7777, for example:
From Claude or any MCP client, the osc-bridge mcp server exposes this driver as space: ask “what can the Eventide SPACE do?” and it reads this map with list_routes. See the MCP guide.
MIDI CC and NRPN parameters (11)¶
| OSC address | CC | NRPN (MSB/LSB) | Range | Nature | Section |
|---|---|---|---|---|---|
/space/mix |
22 | 0–127 | continuous | ||
/space/decay |
23 | 0–127 | continuous | ||
/space/size |
24 | 0–127 | continuous | ||
/space/delay |
25 | 0–127 | continuous | ||
/space/low |
26 | 0–127 | continuous | ||
/space/high |
27 | 0–127 | continuous | ||
/space/active |
15 | 0–127 | continuous | ||
/space/xnob |
28 | 0–127 | continuous | ||
/space/ynob |
29 | 0–127 | continuous | ||
/space/fx_mix |
30 | 0–127 | continuous | ||
/space/contour |
31 | 0–127 | continuous |
Performance MIDI¶
Notes, pitch bend and any CC are also available: /space/note/on <note> <velocity>, /space/cc/<number> <value>, /space/pitchbend <0-16383>, /space/program_change <n>.
Limitations¶
Imported from an Electra One community preset. The mapping reflects the preset author's editorial choices: parameter naming, ranges, and which params are exposed. Untested on hardware in this repo.